Solid Wire Electrode BA-WIRE 430 for Submerged Arc Welding
EN ISO 14343-A: S 17
SFA 5.9: ER430
Wire electrode for submerged arc welding intended for welding ferritic and martensitic chromium steels with 15-17%Cr, AISI 430.Also suitable for surfacing gas, water and steam valves and fittings. Service temperatures up to +450 °C. Scaling resistant up to +950 °C.
Typical analysis and chemical composition acc. to EN ISO 14343-A and AWS A5.9
|Wire electrode||C||Si||Mn||Mo||Ni||Cr||P||S||Cu total|
|Typical analysis BA-WIRE 430||0.04||0.35||0.5||0.1||0.1||16.5||0.015||0.015||0.2|
|S 17 acc. to ISO 14343-A||0.12||1.0||1.0||0.5||0.5||16.0 - 19.0||0.03||0.02||0.5|
|Er430 acc. to AWS A5.9||0.10||0.5||0.6||0.75||0.6||15.5 - 17.0||0.03||0.03||0.75|
Surfacing: all weldable backing materials, unalloyed and low-alloyed.
Joining: corrosion resistant Cr-steels as well as other similar-alloyed steels with C-contents up to 0.20 %.
AISI 430 Ti; AISI 431
Suitable fluxes: BF 38, WP 380
Flux type suitability is strongly dependent on its application. In combination with the wire electrode the most suitable flux should match the requirements of the plate material as closely as possible under the existing welding conditions. Further information can be obtained from the technical flux data sheets.
Coils, spools, drums and spiders as standard package forms for SAW-wire electrodes, different package forms on request.
1.6 – 4.0 mm; sizes and tolerances acc. to ISO 544 and AWS A5.9.
Wire Electrode Surface
Smooth finish free from surface defects and foreign matter.